In short, this is a cheap, thin and low quality egg slicer (see the video or pictures that follow). It's so thin, that it arrived somewhat bent despite a good packing job. The frame was bent back to it's original position, so the wire slicers would fit in the grooves. However, it doesn't take long for the frame to bend again. That means the wires hit the ledge. It takes some coaxing to get all the wires full depressed. I can't recommend this product unless you are looking for a cheap, temporary egg slicer (because everyone needs one of those, right?)
FEDERAL TRADE COMMISSION (FTC) DISCLAIMER:
I received this product for free. However, the opinions expressed herein were formulated based on my personal use of the product. I welcome all suggestions, feedback and/or product questions!
No comments:
Post a Comment